Hotpoint Fridge Freezer Troubleshooting

Hotpoint NRFAA50x Fridge Freezer Troubleshooting

Problem Solution
The internal light does not illuminate• The plug has not been inserted into the electrical socket, or not far enough to make contact, or there is no power in the house
The refrigerator and the freezer do not cool well.• The doors do not close properly or the seals are damaged.
• The doors are opened too frequently.
• The TEMPERATURE ADJUSTMENT knob is not in the correct position
• The refrigerator or the freezer have been over-filled.
The food inside the refrigerator is beginning to freeze.• The TEMPERATURE ADJUSTMENT knob is not in the correct position.
• The food is in contact with the back inside wall of the refrigerator
The motor runs continuously.• The door is not closed properly or is continuously opened.
• The outside ambient temperature is very high.
• The thickness of the frost exceeds 2-3 mm
The appliance makes a lot of noise.• The appliance has not been installed on a level surface
• The appliance has been installed between cabinets that vibrate and make noise.
• The internal refrigerant makes a slight noise even when the compressor is off. This is not a defect, it is normal.
There is water at the bottom of the refrigerator.• The water discharge hole is blocked
Excess moisture / Ice at rear of the Fridge• Excess moisture / Ice will occur if the Larder door is opened for prolonged periods. This will disappear once the door is closed and the Larder allowed to defrost and drain the moisture away.
This is normal for cooling function of the Larder compartment, especially in summer period.
Warm Fridge• If room temperature is 16 C or lower, (for example the product is located in a garage or out building), for the refrigerator to operate correctly the “Fast Freeze switch" must be in the ‘ON’ position
The back wall of the refrigator unit is covered in frost or droplets of water• This shows the appliance is operating normally.

Hotpoint LEX85 XX X Fridge Freezer Troubleshooting

Problem Solution
The internal light does not illuminate• The plug has not been inserted into the electrical socket, or not far enough to make contact, or there is no power in the house.
• The TEMPERATURE ADJUSTMENT knob is not in the correct position
The motor does not start• The appliance comes with a motor protection control
The refrigerator and the freezer do not cool well• The doors do not close properly or the seals are damaged.
• The doors are opened too frequently.
• The refrigerator or the freezer have been over-filled
The food inside the refrigerator is beginning to freeze• The TEMPERATURE ADJUSTMENT knob is not in the correct position
The motor runs continuously• The door is not closed properly or is continuously opened.
• The outside ambient temperature is very high
The appliance makes a lot of noise• The appliance has not been installed on a level surface
• The appliance has been installed between cabinets that vibrate and make noise.
• The internal refrigerant makes a slight noise even when the compressor is off. This is not a defect, it is normal
Some of the external parts of the refrigerator become hot• These raised temperatures are necessary in order to avoid the formation of condensation on certain parts of the product

Hotpoint XUL8 T2Z XOV.1 Fridge Freezer Troubleshooting

ProblemPossible CauseSolution
The appliance is not workingThere may be an appliance power supply problem.> Check if power cable plugged into a live socket with the proper voltage.
> Check if the protection devices and fuses of the electrical system in your home
There is water in the defrost panThis is normal in hot, damp weather. The pan can even be half full.> Make sure the appliance is level so that the water does not overflow.
The edges of the appliance cabinet, which come in contact with the door seal, are warm to the touchThis is not a defect.This is normal in hot weather and when the compressor is running.
The light does not workThe light may need replacing.> Make sure if the protection devices and fuses of the electrical system in your home work well.
The appliance may be in On/ Stand-by model.> Check if the power cable is plugged into a live socket with the proper voltage.
> In case the LEDs are broken the user must call the Service for exchange of the same type available only at our After-sales Service Centers or authorized dealers.
The motor seems to run too muchMotor running time depends on different things: number of door openings, amount of food stored, temperature of the room, setting of the temperature controls.> Make sure that the appliance controls are correctly set.
> Check if there is not a large amount of food been added to the appliance.
> Check that the door is not opened too often.
> Check that the door close properly.

Hotpoint FFU4DG X MTZ Fridge Freezer Troubleshooting

Problem Solution
The display is completely switched offThe plug has not been inserted into the electrical socket, or not far enough to make contact, or there is no power in the house
The motor does not startThe appliance comes with a motor protection control
The display is on but it is dimPull out and reverse the plug before putting it back in the socket
The alarm sounds and DOOR OPEN ALARM flashes on the display (flash the set temperature in the refrigerator).The refrigerator door has been open for more than two minutes. The sound alert stops when the door is closed or when the appliance is switched off and on again
The alarm sounds and TEMPERATURE ALARM flashes on the display (“A1" is displayed instead of the FREEZER temperature).The temperature inside the freezer is too high. The freezer will maintain a temperature of around 0°C so that the food will not refreeze, allowing you to eat it within 24 hours or to refreeze it after it has been cooked
To switch off the buzzer, open and close the appliance door or press the + and - freezer temperature adjustment buttons once. Press these buttons a second time to display the set value on the freezer display, switch off the TEMPERATURE ALARM LED and restore normal operation
The alarm sounds and temperature alarm flashes on the display (“A2” is displayed instead of the FREEZER temperature)The temperature of the freezer is dangerously high: the food inside must not be eaten. The freezer will maintain a temperature of approximately 0°C
To switch off the buzzer, open and close the appliance door or press the + and - freezer temperature adjustment buttons once. Press these buttons a second time to display the set value on the freezer display, switch off the TEMPERATURE ALARM LED and restore normal operation
The refrigerator and the freezer do not cool wellThe doors do not close properly or the seals are damaged.
The doors are opened too frequently.
The temperature that has been set is too high
The refrigerator or the freezer have been over-filled
The food inside the refrigerator is beginning to freezeThe temperature that has been set is too low
The motor runs continuouslyThe QUICK FREEZE button has been pressed (rapid freezing): the yellow QUICK FREEZE light is on or flashing
The door is not closed properly or is continuously opened
The outside ambient temperature is very high
The appliance makes a lot of noiseThe appliance has not been installed on a level surface
The appliance has been installed between cabinets that vibrate and make noiseThe internal refrigerant makes a slight noise even when the compressor is off. This is not a defect, it is normal.
Early ending of functionsElectrical disturbance on the network or brief interruptions of the power supply.

Hotpoint SXBHE925WD Fridge Freezer Troubleshooting

Problem Solution
The motor does not startThe appliance comes with a motor protection control
The refrigerator and the freezer do not cool wellThe doors do not close properly or the seals are damaged.
The doors are opened too frequently.
The refrigerator or the freezer have been over-filled.
The food inside the refrigerator is beginning to freeze.The temperature is not adjusted properly
The food is near the back inside wall of the refrigerator.
The motor runs continuously.The SUPER FREEZE button has been pressed
The door is not closed properly or is continuously opened.
The outside ambient temperature is very high.
The appliance makes a lot of noiseThe appliance has not been installed on a level surface
The appliance has been installed between cabinets that vibrate and make noise
The internal refrigerant makes a slight noise even when the compressor is off. This is not a defect, it is normal
Any indicator lights do not illuminateIf the function 1 Care is not the plug has not been inserted into the electrical socket, or not far enough to make contact, or there is no power in the house
The indicator lights are on but the light is dimPull out and reverse the plug before putting it back in the socket
The alarm soundsThe refrigerator door has remained open for more than two minutes (the buzzer will stop sounding when you shut the door) or the correct switching-off procedure was not followed
The alarm sounds and the two blue indicator lights flashThe temperature in the freezer is too high. Check the quality of the food products and dispose if necessary
The alarm sounds and the two blue indicator and green one lights flashThe temperature in the freezer has reached a dangerous level. The food must be disposed immediately

Hotpoint Quattro HPSN 4T Fridge Freezer Troubleshooting

Problem Solution
The interface is off• The plug is not inserted in the outlet, or it is not powerful enough to create a contact, or there is no electricity in the house
The motor does not start• The appliance comes with a motor protection control
The alarm sounds• The refrigerator door has remained open for more than two minutes (the buzzer will stop sounding when you shut the door) or the correct switching-off procedure was not followed
The refrigerator and the freezer do not cool well• The doors do not close properly or the seals are damaged.
• The doors are opened too frequently.
• The FRIDGE TEMPERATURE is not correct
• The refrigerator or the freezer have been over-filled
The food inside the refrigerator is beginning to freeze• The FRIDGE TEMPERATURE is not correct
• The food is in contact with the back inside wall of the refrigerator
The motor runs continuously• The SUPER button was pressed: the yellow SUPER indicator is on
• The door is not closed properly or is continuously opened.
• The outside ambient temperature is very high
The appliance makes a lot of noise• The appliance has not been installed on a level surface
• The appliance has been installed between cabinets that vibrate and make noise.
• The internal refrigerant makes a slight noise even when the compressor is off. This is not a defect, it is normal
The back wall of the refrigerator unit is covered in frost or droplets of water• This shows the appliance is operating normally